• Modular Design: Up to 12 FXS, FXO or mixed FXS/FXO ports per card. Each port can be setup as FXO or FXS by plugging in diferent modules in it.
• Firmware accelerates I/O access to achieve high stability and highly decreased CPU payload (1pc of A1200p with 12 modules installed use less CPU cycle than 1 pc of TDM400p with 4 modules installed).
• Low CPU payload: below 25% with 8 pcs of A1200p (96 ports) after driver installed, , on a Celereon D 2.53.Ghz.
• Scalable: Just add additional cards to extend system.
• Easy to use: Module Pin to Pin compatible with x100m and s100m. You can use digium’s x100m/s100m module on this card, or use our FXO-100/FXS-100 Module on TDM1200p.
• World Wide Usable: Configurable line interface to meet global telephone line interface requirements.
• High Quality at Low Price.
• Application ready: Use Asterisk to build your IP-PBX/Voicemail system.
• Excellent choice of upgrade your TDM400p based Asterisk system to A1200p, achieve 96 port density or more in one PC, and protect your investment by directly make use of your investment on modules of TDM400p.

• Industry standard: PCI 2.1 supports both 3.3 volt and 5 volt PCI slot.
• Software-programmable, meets global telephone line requirement
• Power consume: <=37W(with full 12 port FXS module). <=W (with full 12 port FXO module).
• Industry standard full size length PCI card.

• Use at least 300 watt power supply for your pc, increased by 30W/12 FXO port.

A1200p Installation Guide Document Rev 0.01

A1200P is a modular analog telephony interface product. It is designed to have equivalent capacity of small to middle business PBX usage. Each A1200P can have up to 12 ports per card, and user can install 4 pcs of A1200p in one PC to get 48 ports.

A1200P must be used with FXO-100 or FXS-100 together to build a workable system. The FXO-100 and FXS-100 module is also pin to pin compatible with x100m and s100m.

Telephone Cable Installation:

The A1200P have 3 RJ45 socket on the bracket. Each jack has 4 corresponding module installed, positioned on the mother board.

Each RJ45 socket has 8 pins, A1200P uses the 2 pins of it as a pair, to connect to your 2-wire telephone line, so each RJ45 sock can connect to 4 telephone lines.

Please see figure 1 and figure 2 for jack and telephone line wire. Software installation:

The A1200p uses a zaptel conform software device driver on linux. User can download the driver from www.openvox.com.cn, and build it in linux system. To use A1200P, you should have zaptel pre-installed.

Certificates: CE, FCC

Two Years Warranty!